Recent content by Jass

I purchased some of this Biopor JF additive and put some in the fuel tank. After a week or so I changed out the fuel filter and drained a bit of fuel from the lines and now my L2501 runs great, so I believe this stuff made a big difference.

I also posted this on the buying advice forum, so ignore if you already saw this. I am considering a purchase of a 2016 Kubota L3301 but have concerns with the EPA Tier 4 compliant emissions system. As I recall there were issues with the early EPA emissions systems on Kubota's. Can anyone shed...

I am considering a purchase of a 2016 Kubota L3301 but have concerns with the EPA Tier 4 compliant emissions system. As I recall there were issues with the early EPA emissions systems on Kubota's. Can anyone shed some advice on this - should I stay away from that?

Does anyone have any experience with the Gearmore Brush Grapples?

I bought seat c overs on Amazon from Durafit. Great covers that last for reasonable cost. https://www.amazon.com/dp/B00N4IUVSG?ref=ppx_yo2ov_dt_b_fed_asin_title

Thanks you for the manual edrichey, most appreciated. I looked at the sites provided above and did not locate the owners/operators manual - might anyone have a PDF copy of that? Thanks in advance.

Sorry, I thought you were referring to a Woods BH75. My bad, nevermind my rambling.

I have a 2016 L2501 in CA and have had an issue causing the motor to bog down on the slightest of grade or workload. The tractor does not get a ton of use and has about 400 hrs on it. Could this diesel mushroom phenomenon be the cause or the bogging down, and might the Biobor JF additive...

From their website there are six hydraulic cylinders each with same diameter (2.48 x 1.26) but different lengths that take the same seal kit pt# 1038997 and one with diameter 1.97 x 1.18 that takes seal kit pt# 1038998. But, maybe their website is wrong? Did you go to the website and check...

German bliss equipment (germanbliss.com) has the seal kits for a bh75 for $40 each, part #'s 1038997 and 1038998. I have a bh7500-1 backhoe and just order seal kits for it but they are a little different from bh75 I guess and cost about $75 each.

Does anyone have a PDF copy of any manuals for a 2006 L3130 or have a suggestion besides the dealer where I might obtain a copy?

Okay, I performed the test described on both outriggers and sure enough the cylinders wanted to extend when I held the levers in the retract position. So, I assume all the cylinders need new seals installed, correct? If that is the case and they all need a rebuild, how difficult are these to...

Thanks. Just to clarify, on step 2 you indicate to "remove the base end hose" - is that the hose that would be closest to the ground when the outrigger is fully extended? Then, on step 3, is that for the same stabilizer that was fully raised up and chained up in step #1? Finially, again on step...

It would seem odd that all of the cylinders would have the seals go out at roughly the same time. Any suggestions on diagnosing and isolating to one or the other?

Thanks for all the replies and suggestions. I use standard diesel from the local fuel stations. I have changed out the fuel filter and I have added Diesel Clean several times, both of which improve the running some, but it still bogs down significantly. Also, the air filter has been changed...