Recent content by whatsupdoc

I drilled holes in the black plastic cover that is over the controls and bolted the monitor to the cover.

I have the exact same tractor and never have I been able to do the auto regen. I have had what you had happen all three lights were flashing, the manual states that you will get the regen light and the rpm light flashing where your need to raise the RPM until the rpm light stops flashing. My...

Vevor is China's Harbor Freight

I have some slopes that I mow, dont know your particular conditions but I will pass on what works for me in my area. I never mow in the morning the dew makes the grass too slippery, I mow backwards uphill with the 3 point finish mower raised about a foot off the ground making a cut on the tall...

Ok so let me throw this into the fire.... What say yee......:LOL: AI Overview Amalie Ultra All-Trac 245 Synthetic Tractor Hydraulic Fluid is often cited as a direct, high-quality alternative to Kubota Super UDT2 (SUDT2) . It is designed to meet or exceed the performance specifications...

$4000 for ball joints, shop must be looking to throw an all you can eat Wagyu party. Ask them what their shop rate is and how much shop time for that job. 5-6 hours MAX.

I own a L3302 at 2300 ft elevation and very hilly. High gear is useless unless I am driving on a level paved road. 90% of the time I am using the finish mower in medium gear and have no lack of power issues with lots of uphill mowing. Moved lots of crushed stone (1-2) and soil with the loader...

So driving backwards is more efficient.

A front mounted snow blower is king, everything else is a compromise.

I had the same issue with my new L3302, called the dealer and they sent a service truck to fill it. I checked all fluids when I first had it delivered and was like WTF. Complete BS, seems that Kubota does not completely fill the axle and its the dealers responsibility to fill it when...

In my world if I go to the trouble of removing a thermostat, I will test the old one and the new OEM one that is going to replace it.

Warm is better, but it may not matter. Even with the grease gun and grease warm if you are trying to grease a cold machine the cold grease in the machine will make greasing more difficult.

There is a reason why folks buy excavators. Rent a small excavator or hire someone to do it, in the long run you will be much happier.

Seems like a safety switch issue.

Before you choose a repair procedure you need to determine what material you are repairing.