Recent content by jimr63

Excellent condition Kubota L4701 2wd 8 speed manual transmission for sale. One owner bought new in mid 2016. 879 hours on tractor. Comes with front end loader, heavy duty loader bucket, rear tires ballasted with Rim Guard, two rear remotes, power beyond port and hydraulic top link. Tractor is at...

Or this!

Yep.

After seeing the video I'm inclined to think it's mounted to the backhoe subframe which I don't have. I'll do as you suggested and wing it. I'm only using 2 of the three pairs of holes for the rear remotes so may just throw the female side in one of those but wanted to see how the factory had...

Yes. I understand the hydraulic circuit I'm trying to add. Hoping someone can tell (show) me where this part gets attached to the tractor. https://www.messicks.com/parts/kubota/7K500-64844

Can someone with an L4701 and BH92 snap a picture of the female hydraulic hose fitting that’s bolted onto the tractor side? I just ordered the hoses and fittings to give myself a power beyond port to run a log splitter but can’t make out from the parts diagram where that fitting gets attached...

I installed a 50 cal. ammo can in front of my fuel tank on the M5.

I wouldn’t disc before plowing. I run a bush hog over stalks to chop them up in the fall then chisel plow it all under. Then I don’t disc until spring and it usually takes me 3 passes with a disc and using a drag harrow behind disc on last pass to create a good seed bed for whatever I’m...

John Deere is the same. Repair manuals come in shrink wrap and you buy your own binder(s).

Both the L47 and M62 have the same 3 point lift capacity so I’d go with the cat 1 setup listed for the lower price. Just my $2. 😏 Wonder if the L3951 lift arms could big longer to account for the larger tires on the M62?

I think there’s two different thumb kits too, I.e. orange vs black in order to mate up with the two different styles of QA buckets. I decided to add a thumb after I bought my L47 and the installation isn’t too hard. The valves are exactly the same, except for having the thumb spool already...

L4701 has 1 hydro pump operating at 7.8 gpm and 2560 psi according to my owners manual.

Looking good! The bucket ears on my B21 were flat so I didn't have to cut them like you're having to do.

Same here. My M5-091 is cat 1 on the tractor side of the top link. I have a bushing on that end to reduce my cat2 hydraulic top link down to cat1.

It’s the exact same control valve body as the one I’m selling except the control valve with the spool for thumb installed at factory was a couple hundred more, so about $3600. Had I known it was the same control valve but with the thumb spool already added I would have just ordered the parts to...