Recent content by jsramrod

You raise very good points. I keep my equipment forever, and take care of it so that I can. I actually started out looking for a front mount but my reason for switching to rear mounts wasn’t cost as much as it was such significantly fewer options available on my older unit. Seems like there’s...

Tractor width is 45” so sounds like at least a 50” unit but could go up to 60” based on ItBMine’s experience. I’ve seen some 51” Land Prides and Lynx units but will expand my search to a little larger. Thanks for all the replies, they got me going in the right direction!

Hadn’t thought much about the width until you mentioned it but makes sense it needs to be wider than the tractor or I’ll be riding on snow. Thanks for the input, search has started on both of those sites.

Thanks for the reply! I’ve used the Kubota plow for all 18 years, but the last 10 spent saying, I really wish I had a snowblower. The rear blower sounds like the ticket, I can leave the plow on for the small amounts and cleanup. There’s a place nearby that sells the Pronovost lines so I can...

Thanks for your reply. Lot of choices on the rear mount side of things.

Hello, I've had a B2320 for 18 years and have finally decided it's time to put a snowblower on it instead of plowing. I've started to look into the whole front vs rear blower question and it seems to me I'll be better off with a rear(I know the backing up will drive me crazy) and keeping the...

I actually didn't have any fuel treatment in it prior to this, but didn't think it had been all that cold. Had gotten down in the 20's at night, but was probably 35 the day I noticed the problem.

Today I took the air filter off and made sure I hadn't done something stupid, looked fine. No new noises, steering seems fine, and I had to put the plow on this morning because we got 6 inches of snow I had to clear. No problems with the plow movement. Replaced the fuel filter when I was...

It's at 410 hrs now and was last done by a dealer at around 250. Just a single filter as far as I can see and that's all the service manual indicates. No smoke other than when first starting, which is black, but clears up immediately after. Going to run out and pick up a fuel filter, then...

Hi All, You all have helped me in the past and hoping someone has some wisdom. Did service last weekend, oil/filter, new air filter, front axle drain and re-fill, then drained the hydraulic system completely(finally found all 4 plugs), replaced both the hydraulic and HSD filters, filled it...

Picked up a 4' at Tractor Supply on Friday, the dual trailing wheel model. It's a countyline brand but pretty sure is the Tarter unit. Got it all put together and adjusted and did a small mow yesterday. Cut nicely, went through some 1" pieces or so. Parked it in the driveway and was going to...

Sounds like the 4' is a safer bet. For the amount of cutting I have to do, the extra foot isn't going to save a whole lot of time. Thanks for your reply.

Hello, Have a B2320 and am looking for a rotary cutter to take care of 2 acres of field, some small saplings, etc. Have read varying opinions on whether a 5' unit is appropriate, or whether a 4' is the one for this tractor. It seems based purely on specs that it can handle a 5 but wondered if...

Hello, Have a B2320 for 4 years now. Shortly after I got it, noticed that the hydrostatic drive would stick, ie, if you let off of it, the tractor kept on going and the pedal would gradually come up and the tractor would stop. Tried greasing the assembly, then asked the dealer to check it...