Search results

I just purchased a used backhoe. i want to make sure it will work ok on my tractor 3pt mount without the subframe mount? There are two different ways to attach the backhoe, one is use the top link (regular 3 pt) and the other way is to use drawbar with a kit that came with the backhoe. when I...

I put a can under the tube like you suggested and after 15 hours of use nothing in the can.

I just discovered that the oil is coming out of the top of the head cover where the bolts and washers. Especially the front two and a little on the third one from the front. I tighten the bolts some and the oil still come out so I just ordered a set of 4 new copper washers. They should arrive...

I noticed that my tractor will stall sometimes when the fuel level gets close to 3/4 when the engine is running at medium speed. No problem with stalling if engine running at high speed. It appears to get worse sometimes when the tractor is going up or down the slope (not steep).

I noticed that my tractor hydraulic system is starting to get hot lately. I recently replaced the fluid, filters and cleaned the strainer. I also replaced all rubber suction hoses. I put in a new 0.2 mm shim and 2 washers in the relief valve as when I took the relief valve plug out, the...

Is it common for the piston rings or valve stem seals to be worn out at 1,400 hrs? Or is there something else I am missing?

I put a can under the tube, now at almost two hours nothing in the can so far.

Any more help?

Yes I did. Also I check the hoses from the air filter housing. No blockage or anything.

Not long ago I did oil and oil filter change on my tractor (@1,400 hrs), I noticed a very brief burnt oil smell, I looked around for leaks but didn’t find any. I have noticed there will be very brief dark black smoke coming out from the exhaust every time I start it, which I believe is normal...

I’ll try it out tonight.

Cool! I live in Texas and bought it in Elgin, TX. Lot of old tractors around here.

I’ll post here on how it goes when I attach it on my tractor.

I’ll take a close look at the cutting edges later today. I am getting ready to take the weight container off the hitch.

Ok I’ll look it up. Thanks

its 5.5 foot too. Thanks for the info about the back part.

Hello, I just purchased an old box blade from a guy who doesn’t know much about it because he just bought the property and the previous owner left the box blade. I need your help with identifying the brand of the box blade and to see if it will work on my B2710. The hitch part on it was...

Yes, I just put the ori shim back in. I found the relief valve on the loader valve housing. i just downloaded the Bush Hog FEL manual explaining how to adjust the relief valve.

Thank you. That’s very helpful. I really appreciate it.

The third one will go to the return port (transmission case).