Search results

I have been at this a while and have repeatedly taken this whole assembly apart and put it back together. The quick connect - when connected - wobbles a lot - unlike the other quick connects. Pretty sure it is the quick connect.

I have a small leak at the quick connect (shown as the one disconnected) or the bolt which goes into the control valve) or the connector that screws into the hose. Does not leak when running but leaks when I shut the Kubota off and let it sit overnight. I have previously used hydraulic tape to...

Turns out its really bent - does not retract. Trying to source a used one - new one at Messicks = ~$200. Yes - tractor runs fine without it. Thanks.

So I should be able to pull it a longer and compress it shorter? Did not feel like it's pliable but I'll see today. If I can pull it a little longer - should I push the pin the hole and clip it in?

I noticed that the pedal damper was disconnected - appears that the clip fell off. When trying to replace it, I fully depressed the pedal but the damper did not quite line up with the hole. My instinct was to bang it in with a hammer - but thought better of it. One thing that concerned me is...

Thank you.

Hmmm?

I took the guard off the drive line to more arcuately measure the play in the shaft. Instead of " 4" of space for additional compaction" set forth in my initial post above - I have 1 1/2 inches. Does that mean I should cut the shafts?

I bought the Cutter in 2004 (used) and have been using it since then on the B-2400. Thank you both for your thoughts.

I have a B-2400 sometimes connected via a quick connect system to a Deere LX-4 Rotary Cutter. I have been bush hogging my property to ~20yrs with this set up with minimal maintenance. The drive line when connected to the tractor and rotary cutter only has about 4" of space for additional...

The Loctite 545 Automotive Pneumatic/Hydraulic Pipe Thread Sealant Purple failed immediately. Brought the tractor to Woodstock Equipment who used epoxy to seal the bolt in the hole - no leak. Hopefully there will be no need to remove the bolt. I say problem solved. Thanks to everyone for...

My brake rod got bent and the disconnected from the brake lever - easy fix. Doesn't sound like your fix is going to be easy.

Sorry replied in wrong post. Too many leaks to keep track of

Sadly, I worked the tractor really hard today moving tree limbs- and it leaked at the same. bolt. I tighten it a little more but it did not bottom out. I used it a little more and it did not leak - but I am doubtful. Assuming it does leak - I have the following plan(s) - 1. I will have tomorrow...

Prior to using Loctite 236382 4.8-ML. Form-A-Thread Stripped Thread Repair Kit, I spoke to Loctite technical support - she said that the product was discontinued over 2 years ago (and there was no similar product from Loctite currently for sale). She indicated that because the product was on...

Got the tractor running today. The sleeve and Permatex Sleeve Retainer High Temp, 64040 held perfectly - no leaks. Glad you responded before I took the rear axle apart. Don't know how you you put "Solved" before the title of this post - but it is. Thank you so much for your help.

Mountainman is on this site has helped me out with parts for a B. He has a salvage yard and has great prices.

Tomorrow is the day I am doing the thread repair. Weather is expected to cooperate. We shall see. Wish me luck. Thanks for all the help.

Thanks for your help again.... Wolfman - I do have a guy who will do this type of welding but thanks for the offer. Thanks to Mountainman, replaced these plugs (stripped bolt heads) and can use the old ones for building the tester. PoTreeMan - I have the Work Shop Manual and will the sections...